| 1. |
What
is the temperature resistance of the final product? |
|
We
have both normal and high temperature resistance products. Normally
working temperature products resists temperature from 93°C
to 121°C while high temperature one's resist upto 232°C. |
|
|
| 2. |
What
product will put machine back in the service? |
|
Fast
Cure Steel Putty, Metal Magic Steel Stick, Wet Surface Repair
Putty, Four Minute Putty are the products which reach full cure
in one hour to eight hours. |
|
|
| 3. |
What
is the chemical resistance of these products? |
|
Each
product has got different chemical resistance properties.
Koroguard GF and Chemguard GF offer the highest chemical resistance
while other products offer moderate to low resistance. One need
to know the PH value of the chemical or concentration of the chemical
before selection of suitable product for the application. |
|
|
| 4. |
What
is the correct mix ratio to work with? |
|
Each
two component kit is premeasured for correct ratio; however mix
ratio's are also printed on the container. |
|
|
| 5. |
What
is the best product for repairing of shaft or bearing housing? |
|
Superior
Metal should be the first choice for the above application. |
|
|
| 6. |
Which
product is suitable for arresting oil leakage? |
|
Fast cure Steel Putty is the suitable product for arresting the
oil leakage from Transformer or pipeline. |
|
|
| 7. |
Which
product will be suitable for protection of ID Fan or Impeller blade
from abrasion or erosion? |
|
All
our abrasion resistance products such as Wearing compound, Pneuwear,
Wear Resistant Putty and Brushable ceramic are suitable for such
application. We need to know the service conditions for recommending
suitable product. |
|
|
| 8. |
Can
the leakage of water through Concrete tank be arrested? |
|
Yes. First apply Metal Magic Steel at the leaky point. Apply wet
surface Repair Putty on the Metal Magic. |
|
|
| 9. |
Is
it required to empty the whole tank? |
|
If
the area is accessible then no need to empty the tank. But always
it gives better result if we can empty the tank and do the application. |
|
|
| 10. |
How
do I Remove Epoxy? |
|
For
the uncured Epoxy, Acetone /MEK can be used as cleaning compound.
By heating upto 175°C, cured products will get dislodged. |
|
|
| 11. |
Where
to get Demech products? |
|
Our
products are sold through authorized industrial Distributors.
Please contact us to know the distributors address who is near
to your locality. |
|
|
